Detailed Explanation of Debugging Methods for air bubble film making equipment

一、 Preparation before debugging

Before starting to debug the air bubble film making machine, some preparation work needs to be done:

1. Confirm whether the machine is securely installed and whether the power cord is securely grounded.

2. Check if all accessories are complete, such as blades, tension controllers, etc.

3. Clean the bubble film bag making machine, including cleaning blades, cleaning waste bubbles, etc.

4. Check the lubrication of various parts of the machine, and if oil is needed, please add it in a timely manner.

二、 Loading debugging air bubble film packing machine

1. First place the bubble film on the unwinding rack, and then introduce the bubble film into the machine according to the working requirements of the machine.

2. Adjust the unwinding rack so that the bubble film can smoothly enter the stretching machine.

3. The stretching machine needs to adjust the appropriate tension to ensure that the bubble film is stretched with moderate tension.

After adjusting the tension, introduce the stretched bubble film into the press.

5. Run the membrane at an appropriate speed and conduct a test run.

air bubble film extrusion machine

三、 Tension control debugging

1. Adjust the tension controller of the bubble film stretching machine to the optimal state, so that the membrane tension is within the appropriate range.

2. During operation, check if the tension is appropriate. If it is not, adjust the tension controller again.

3. For situations where the membrane tension is too high or too low, adjustments need to be made according to the actual situation.

四、 Cutting debugging

1. Adjust the height of the blade to ensure that it can cut the bubble film.

During the test run, observe whether the blade can cut the film normally. If not, further adjustment of the blade height is necessary.

After adjusting the height of the blade, it is necessary to check whether the cutting effect is ideal. If there are any abnormalities, it is necessary to adjust or replace the blade in a timely manner.

五、 Other debugging

1. Adjust the heat sealing time and pressure to ensure reasonable heat sealing quality.

2. Adjust the labeling position and tension to achieve better labeling effect.

3. Adjust the tension and speed of the winding frame to ensure the quality of bag making.

Conclusion: Through the above debugging steps, the bubble film bag making machine can operate normally and the bag making effect can also reach the ideal state. In actual production, it is necessary to continuously adjust and maintain to ensure the normal operation of the machine and the quality of bag making.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975