Details for using printing slotting die cutting machine

With the increasing prosperity of our electronic products, our traditional printing industry has been impacted to a certain extent, and at the same time, higher printing requirements have been put forward for our printing industry. This has led to the use of highly configured equipment in our printing industry, increasingly using high-speed printing machines. So, what are the details to pay attention to when using flexo printer slotter die cutting machine?

1. Start at low speed and full load, the acceleration and deceleration machine runs steadily, and the noise is low;

2. High speed dot reproduction rate, bright layered printing effect, and strong three-dimensional sense;

3. The aluminum guide roller adopts Japanese semi closed bearings and undergoes oxidation treatment, with high surface hardness. It is subjected to dynamic and static balance treatment;

4. Special gears are used for rolling, with a more accurate printing scale. The printing standard is 5mm per tooth;

5.automatic flexo printing die cutting slotting machine equipped with a heating and blowing system for centralized control of drying temperature, and equipped with a cool air shaping device;

6. Stop the machine and start printing to ensure that the printing plate roller rotates without drying the ink;

7. Use pneumatic expansion shaft for data clamping;

8. Active tension control, central winding or conflicting winding are used for winding and unwinding;