The thin blade slitter scorer machine dopts thin knife technology for slitting, overcoming the burrs and flattening caused by traditional thick angle knife slitting. The cut cardboard does not have inverted corrugation, burrs, neat edges, smooth and flat edges, and has good straightness, improving the overall quality and appearance of the cardboard.

Operation process of the auto feeding thin blade machine :

First, Preparation work

1. The operator usually consists of two people, one for operating the main machine and one for feeding and receiving paper. If multiple materials are cut separately, an additional person for receiving seasoning will be added.

2. Separate products must be checked according to the “Production Work Order” and the first inspection record must be filled out.

Second, Debugging the cardboard box automatic thin blade slitter equipment

1. Adjust the position of the backup plate (baffle) according to the work order, and adjust the lateral position of the cutting knife from the baffle in sequence. It is advisable to overlap the upper and lower knives with the knife base by 2mm. When adjusting the knife, pay attention to the simultaneous movement of the knife and the base support.

2. If you need to press the line, adjust the same as before and adjust the concave and convex wheels according to different ridge shapes. The upper and lower wheels must be aligned. When not pressing the thread, turn the upper and lower wheels to one side or stagger them, and raise all the pressure.

3. If the cut cardboard is skewed, a line pressing wheel can be used as the paper wheel, but it should be pressed at the duty edge dividing position to ensure that there is no excess line pressing on the finished cardboard.

4. During operation, the assistant worker should concentrate on organizing the cardboard in a timely manner. The cardboard should be packed according to the required number of sheets and neatly stacked on the cardboard.

5. Cutting products should not be cut on rough edges. Timely grinding should be carried out to ensure that the thin blade is sharp. The grinding wheel should be adjusted correctly to ensure that the gap between the grinding wheel and the blade is consistent.

6. During normal production, accumulate paper on the paper supply table with a moderate height. If the paper is fed too high, the bending will increase, and the corrugation will be damaged, resulting in cardboard creases. The feeding should be done on a single sheet, and the overlapping feeding of pads and other materials can exceed 3 sheets.

7. When there is a knife jam or paper jam, stop the carton box thin blade slitter slotter machine  immediately and do not directly touch it with your hands when starting the machine.

8. The cut cardboard should be neatly stacked and should not be stacked too high. Timely detection of defective products is compared to recording.

9. When cutting products with smaller sizes, be sure to keep your hands at a distance. Remember safety.

Third, End

1. After completing each order, open each group for the next order adjustment, clean the site, and clean the equipment. Mark the semi-finished products after pressing the bars and transfer them to the next process for processing to ensure the accuracy of product quantity.

2. After the end of this shift, complete the handover after work, carefully fill out the daily report and handover records, and turn off the power at the end of the entire day’s work. Clean the site, clean the thin knife machine, and keep all records and submit them to the production office.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975