Technical requirements for the use of automatic hardboard production line :

1. When using the initial strip, the tension should be adjusted to a suitable position, that is, not loose or tight.

2. When discovering the contraction of the strip, adjust the tensioner in a timely manner to relax the tension adjustment.

3. During operation, the strip should always be careful not to deviate, and in case of deviation, it must be adjusted in a timely manner. The adjustment method is as follows: (according to the structure of the machine) the strip runs to the right, and the right deviation adjustment device is loose; On the contrary, run on the left and loosen on the left; Please note that the adjustment amplitude should not be too large each time. If it is too large, it will cause the board to deform (note: the degree of deviation varies for different specifications of cardboard).

4. Regularly check the fixed length of the hooks on both sides of the board to prevent the hooks from sticking out during operation.

5 ply hardboard production line

5. To prevent the strip and cardboard from staying on the hot plate during shutdown, it is necessary to support the strip and cardboard to leave the surface of the hot plate to prevent them from coking and damaging the strip surface.

6. After the end of the shift, it is necessary to use a dry cloth or a brush dipped in water to clean the board and tape (not afraid of water), and do not leave paper scraps and other dirt on the surface of the tape. It is also important to prevent adhesive contamination of the board and tape. It is necessary to keep the strip surface clean to ensure that the breathability of the strip is not affected and to ensure the quality of the cardboard.

7. Thorough cleaning should be carried out once a month (before implementation, a written plan should be submitted to the workshop for technical approval). Firstly, the machine should be turned on and run slowly, with water spraying to fully moisten the plate and strip. An appropriate amount of detergent should be added, and a brush should be used to clean. After cleaning, rinse with water once, and if necessary, steam should be turned on and slowly turned on for drying.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975