The paper table of  carton machinery is driven by hydraulic oil pump for lifting action. The upper and lower limit travel switches can effectively prevent mechanical accidents caused by lifting overrun; What the photoelectric device can control is the automatic rise of the machine to maintain the normal paper feeding height; When adjusting the gap, the paper feeding wheel uses an electric adjusting device, which is suitable for different types of corrugated boards with different thicknesses; It is easy to find that the above faults are easy to occur when the quality of flat wire is poor, the resistance of wire feeding is large, the spring of wire feeding wheel is too loose or too tight, the screw fixed by wire feeding wheel is loose, the guide rail is offset, the gear bite is skewed, the position of bottom die and punch is incorrect, and the bottom die is obviously worn.

When the counting photoelectric induction intensity of the right baffle is too strong, the above faults are easy to occur. Therefore, the I-shaped knob on the side of the electric eye can be adjusted. Clockwise adjustment can increase the induction intensity, counterclockwise adjustment can reduce the induction intensity, and it is appropriate to adjust it to normal induction, so that there is no abnormality after nailing. The solution is: use * * flat wire with good rigidity and smooth surface coating; Check whether each part of the lower feeding line will be blocked due to poor adjustment; Adjust the relevant parts of the machine so that the wire feeding movement can be maintained easily and freely; The severely worn bottom mold shall be repaired or replaced accordingly.

When there are staples in the mechanical stapling head of the nailing box and carton, it is often

easy to affect the normal action of the clutch. You can disassemble the side cover of the stapling head, take out the punch for cleaning and cleaning, add lubricating oil and then reinstall it; If the positioning of the set head is inaccurate, check whether F3 fuse 34-35 (AC), F9 fuse 50-51 (DC) and brake coil resistance wire (15 Ω) are normal; If the photoelectric induction switch of the upper stapling head baffle does not act and cannot sense the axis of the lower guide rail, resulting in nailing before paper is fed, the induction distance of the photoelectric switch can be adjusted; If the nail head has continuous nailing action, check whether the electrical appliance is damaged.

If the photoelectric induction of the baffle is not normal, this fault is easy to occur. The photoelectric induction device can be adjusted to maintain an appropriate induction distance, and the baffle can operate normally after the paperboard is sent into the. The automatic counting optical eye automatically counts the finished products and records the output, and can set the separation and delivery; The stapling head of the nail box machine is refined from special steel, which has wear-resistant and practical effect; The electronic control system of carton machinery uses a color touch screen to provide a good man-machine interface to complete the automatic setting of nail distance, the setting or cancellation of reinforcing nails and fault finding.

Tom (oversea manager) Phone:0086 13303078975 / 17772697357(whatsapp,wechat,line)

Email :cartonmachine.tomwang@aliyun.com

https://www.wd-cartonmachine.com