The uneven support force of each layer of cardboard in the high speed ink printing machine will also cause the vertical expansion and contraction of the cardboard. Pay attention to adjusting the transport support force of the tissue paper and each layer of cardboard. Different production line equipment produces different printing paper, and different printing paper production places have different wrinkle orientation and wrinkle rate.

Different printing paper lot numbers and stacking standards will make the moisture content of printing paper different. The old conveyor belt will harm the moisture volatilization of the upper cardboard due to poor air permeability, and make the upper cardboard digest and absorb the steam in the basic cardboard, and cause the moisture digestion and absorption deformation.

The old production line should pay attention to prevent carelessness. If you understand the basic principle and the recuperation method of the production line, after careful investigation and careful analysis, and select the appropriate adjustment method, you can clean and understand the great economic situation of the commonly used heating plate and the production line at normal temperature.

water ink printing slotting machine

The paper table of the ink press is driven by a hydraulic pump to lift the hydraulic cylinder. The left and right limit switches can avoid mechanical equipment accidents caused by too many elevator parts. The optical equipment can operate the fully automatic elevator of the equipment to maintain the normal feeding width ratio. During adjustment, the paper wheel shall be electrically adjusted.

Suitable for different kinds of corrugated boxes with different thickness; When nailing the box, it is very easy to find that the flat line is not good, the friction resistance of the feeding line is large, the feeding wheel is too loose or too tight, the screw of the feeding wheel is loose, the slide rail is offset, the teeth of the transmission gear bite and tilt, the position of the bottom mold and the punching needle is wrong, and the bottom mold is clear. When significant wear occurs, it is very easy to generate the common faults.

When the optical magnetic induction reactance of the right diaphragm is counted, it is very easy to produce this common fault. Therefore, the single-type knob on the side of the color code sensor can be adjusted. The clockwise adjustment can reduce the magnetic induction compression, while the reverse adjustment can reduce the magnetic induction compression.

Moderately adjust the normal induction, so that it is not easy to find abnormal conditions after nailing. The way to deal with this problem is to select flat stainless steel wire, stainless steel plate material is good, and the surface coating is smooth and clean; Check whether the parts of the coaxial cable are not well adjusted to see if they are blocked; Adjust the relevant position of the equipment to make the knife walking position relaxed and comfortable; And repair or replace the worn bottom formwork relatively.

When the stapling head of the stapling machine has needles, it is very easy to endanger the normal position of the clutch. Be able to remove the punching needle from the side cover of the binding head for cleaning and cleaning, and then refill it after adding lubricant. If the binding head is positioned, the fuse and the resistor of the brake system solenoid coil can be checked.

If the optical sensor fixing the fixed head partition does not move, it is not allowed to check the lower slide rail, resulting in the nailing and card punching condition when the printing paper is not fed in. The magnetic induction spacing of the photoelectric switch can be adjusted; If the nail head is in a continuous nailing and punching position, check whether the household appliance is damaged.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975